Difference between revisions of "128-pin Module Family"
From MotoHawk
Jump to navigationJump to searchDale Ochalek (talk | contribs) (link update) |
|||
| Line 13: | Line 13: | ||
= Tips = | = Tips = | ||
| − | * Think of EST1-12 | + | * Think of EST1-12 and EST13-16 as two separate banks |
* Avoid mixing Behaviours within a bank where possible, as it can potentially restrict DriverModes and Diagnostic Capability. | * Avoid mixing Behaviours within a bank where possible, as it can potentially restrict DriverModes and Diagnostic Capability. | ||
Revision as of 14:05, 9 October 2007
Contents
Overview
There are two types of PCM128
Hi-Vol
- 1024K Flash
- NO Parallel EEprom (PROD style)
- 32K Serial EE
- 36K RAM
Lo-Vol
- 1024K Flash
- Parallel EEProm (DEV Style)
- 32K Serial EE
- 1024K RAM
Tips
- Think of EST1-12 and EST13-16 as two separate banks
- Avoid mixing Behaviours within a bank where possible, as it can potentially restrict DriverModes and Diagnostic Capability.
FAQ
What's special about EST13 to EST16?
- These pins have stronger LowSide Drivers and can sync higher current
- The hardware can be configured as PUSH_PULL or LOW_SIDE drive
- Current MotoHawk (0.8.4b8) Sets the DriverMode to LOW_SIDE for DIO, OneShot but PUSH_PULL for PWM.
- The Hi-Vol PCM128 does not have pull-up transistors, so technically cannot be configured as PUSH_PULL but the polarity remains active high.
- When instantiating from ControlCore as a LOW_SIDE it makes them active low instead of active high.
Why am I getting a ERROR_DRIVER_CONFLICT?
Where have DG5, 6,7,8 Gone?
You will get "Hardware Not Supported" if you use a Low-Vol. These resources are consumed as part of the KNOCK2 device.
Where is my KNOCK2?
The Hi-Vol only has KNOCK1
