MotoHawk:Blocks:Injector Sequence Out

Injector Sequence Out

This MotoHawk™ block defines defines a fuel injector pulse sequence.

Block ID

motohawk_seq_out_inj

Library

MotoHawk_lib/Advanced Digital I/O

Description

This block generates a series of pulses, starting at a given encoder crank angle, and either stopping at an angle or after a certain duration. Stop Mode parameter selects which strategy to use.

Two of these blocks may be used on a single Injector resource, to generate interleaved pulses, sharing a single pin. Each block must identify the pulse number (0 or 1). If no interleaving is needed, simply use pulse number 0.

Pulse Angle Offset is used to apply a fixed offset to the given pulse, relative to TDC. The start and stop angles are then relative to this offset.

The Update Mode selects whether the OS should protect against missing pulses and double pulse generation. If Application is selected, no error checking is provided, and the application is completely trusted. If OS is selected, some amount of checking is done by the OS.

Pulses are only generated while the Enable input is True.

Angle inputs are before TDC (BfTDC), in units of 1/16th of degree crank angle. Time inputs are in microseconds. Eg: 730degBfTCD == 10degBfTDC == -710degBfTDC

Angles are converted internally to Mod(angle, DegInCycle). It is therefore not possible to schedule a pulse more than one cycle into the future. When Mod(start - stop,DegInCycle) == 0, angular duration is considered to be zero. For example, this will occur on a 4-stroke when start = 720, stop = 0. To achieve a maximum angle, stop = start - DegInCycle - 1/16.

Block Parameters

Parameter Field	Values	Comments/Description
Resource	Drop-down list	Select from available listings, as appropriate, to apply output.
Pulse Number	0, 1	Set as needed if using interleaved pulses (two pulse blocks feeding the same resource). One pulse block would be set to 0, the other, to 1.
Pulse Angle Offset (deg)	Numeric	Enter value for degree of angle offset from TDC
Stop Mode		Select method for Stop
	Angle Controlled	Control Stop Mode by Angle
	Duration Controlled	Control Stop Mode by Time Duration
Update Mode	OS/Application	Select OS to have the system update for errors. Select Application to allow the application to run without updates.
Granularity	Fine or Course	Fine granularity (resolution) interpolates engine position between encoder teeth. Can result in reduced maximum duty cycle for MPC5xx based modules. Course granularity does not use interpolation. Angles resolve to the closest encoder tooth. Modules besides those cores that have an MPC5xx ignore this setting and utilize fine granularity irrespective of this setting.
Input Max Duration Port	Check box (enable)	Select to deploy input to control Maximum duration or port output
Minimum Duration Mode	Static or Dynamic	Only applicable to MPC5xx based modules. Any scheduled electrical injector duration smaller than this value is considered to have zero duration when scheduled. Is a member of the mask when the static Minimum Duration Mode is selected and is a signal when dynamic is selected.
Minimum Duration (ms)	Numeric	Enter value for injector duration. Only applicable if a Static Minimum Duration Mode was selected.