MotoHawk XCP Slave Blockset
XCP Slave Blockset
The Woodward Custom XCP Slave blockset can be used in a MotoHawk model to enable connection of a device to a 3rd party tool to enable calibration, data aquisition, reflash, and security by XCP. Examples of 3rd party tools include INCA, ATI Vision, and CANape, as well as Woodward's Toolkit.
The XCP Slave Blockset is considered a BETA level blockset, and is not yet externally released
The Blockset
Click Here for a complete listing of the MotoHawk blocks in the XCP Slave Blockset and their respective help pages.
Features Supported
The Woodward Custom XCP Slave blockset supports
- Data Aquisition
- Calibration
- Reflash
- Security
- ASAP2 and SR file generation appropriate for 3rd party tools
However, not all features are supported on all hardware. STEM (reverse data aquisition STIMulation) is not supported.
Modules Supported
The Woodward Custom XCP blockset is supported for calibration, display, and reflash for all "MotoCoder" modules released in 2013 and later. These include:
- ECM-OH (main): ECM-5644-112 and ECM-5642-112
- ECM-MI: ECM-5643-70
- LECM: Large Engine ECM
And all modules going forward.
The Woodward Custom XCP blockset is supported for calibration and data aquisition; however, reflash over XCP is not supported for the following modules:
- 24-pin modules
- ECM-OH Auxillary Processor (S12G)
- ECM-5554-112
- ECM-S12X-70
MotoTune or MotoService is required to reprogram the above modules.
The XCP Slave Blockset is not supported on:
MotoTune or MotoService must be used for Data Aquisistion, Calibration, as well as programming of these modules.
